Charge Maintenance Socket; Opening/Closing The Garage Door; Display - Mercedes-Benz Coupe Operator's Manual

same programming steps with this remote
control. Before performing these steps,
make sure that new batteries have been
installed in garage door drive remote
control A.
Note that some remote controls only
R
transmit for a limited amount of time (the
indicator lamp on the remote control goes
out). Press button B on remote control
A again before transmission ends.
Align the antenna cable of the garage door
R
opener unit. This can improve signal
reception/transmission.

Opening/closing the garage door

Once programmed, the integrated garage
door opener A will assume the function of
the garage door system's remote control.
Please also read the operating instructions
for the garage door system.
Select key position 2 with the Start/Stop
X
button.
Press button ;, = or ? which you have
X
programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp : lights up green.
Garage door system with a rolling code:
indicator lamp : flashes green.
i
The transmitter will transmit a signal as
long as the button is pressed. The
transmission is halted after a maximum of
ten seconds and indicator lamp : lights
up yellow. Press button ;, = or ? again
if necessary.
Clearing the memory of the integrated
garage door opener on the rear-view
mirror
Select key position 2 with the Start/Stop
X
button.
Press buttons ; and ?.
X
The indicator lamp lights up yellow.
Press and hold buttons ; and ? until the
X
indicator lamp turns green.
i
Make sure that you clear the memory of
the integrated garage door opener before
selling the vehicle.

Charge maintenance socket

The battery may drain if the vehicle is left
stationary for long periods. In this case,
Mercedes-Benz recommends attaching the
trickle charger to the charge maintenance
socket.
The charge maintenance socket is designed
solely for connecting a trickle charger. A
trickle charger can be obtained from an
authorized Mercedes-Benz Center, for
example.
Switch the ignition off.
X
Open the trunk lid.
X
Connect the cable provided in the trunk to
X
the trickle charger.
Connect the trickle charger to charge
X
maintenance socket :. Consult the
manufacturer's operating instructions on
how to do so.
i
A trickle charger connected to charge
maintenance socket : only maintains the
current charge level of the vehicle's
electrical system battery. If the vehicle's
electrical system battery is discharged, it
needs to be charged with a battery charger.
You will find further information on
charging the battery on (
Features
211
page 236).
Y
Z