Table of Contents
Advertisement
Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes.
Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department
or after-sale service department of our company. Do not repair it by yourself.
Phenomenan
After the reserve is started, it rings and the
digital tube displays E0
The draining does not work ,or the speed of
draining is too slow. The digital tube displays
E1 and it rings.
It stops running during spin .the digital
tube displays E2 and it rings.
The safety switch acts. The spinning
can not work (after twice revising)
The digital tube shows E3 and it rings.
It does not do water inlet or the speed
is slow ( the water level is not reached
after15 minutes). The digital tube
displays E4 and it rings.
the machine does not act .
(The indicators are off.)
There's abnormal sound inside
the machine.
The water faucet leaks.
Common phenomena
Phenomena
The spinning is intermittent when it starts.
Push the PROCESS button to select SPIN, but it doesn't work.
The pulsator pauses during water inlet in wash and rinse.
There may be some water flowing out of the drain hose in the first
use of the machine.
The reason
*
The top lid is not closed.
Is the drain hose put down?
*
*
Is the drain hose blocked by
foreign material?
The top lid is not closed.
*
*
Are the laundries put slantingly?
*
Is the machine slanting?
Is the water faucet open or is there water
*
supply failure?
*
Is the water inlet valve blocked.
Is there power failure?
*
*
Is the power plug loose?
*
Is the machine slanting?
Is there metal material inside the
*
washing machine?
Are the laundries slanting in spinning?
*
*
Is the jointer screw of the water inlet
hose loose or twisted awry?
Balance the laundries to avoid slanting.
The program is setting the drain time. Some time is needed
before it starts spinning.
It is to avoid splashing during water inlet.
It is the water remained in the factory inspection of performance.
How to settle
*
Close the top lid.
Put down the drain hose.
*
Open and close the top lid once.
*
Clean the foreign material .
Open and close the top lid once.
Close the top lid.
*
*
Re-order the laundries. Close the top lid.
*
Level the machine in right position.
Open and close the top lid once.
Open the water faucet.
*
Open and close the top lid once.
*
Clean the water inlet valve .
Open and close the top lid once.
Use it when the power is on.
*
*
Insert the power plug tightly.
*
Level the machine properly.
*
Fasten the fastener or zip up the zip.
Re-order the laundries. Close the top lid.
*
*
Fasten the jointer screw properly.
Explanation
Advertisement
Table of Contents
