Necessary Settings before Use
Be sure to configure the following three
settings before use.
Charging the Battery Pack
1
Close the LCD monitor to turn off the
camera.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camera
3
Connect the AC adapter.
DC Jack
AC Adapter
•
Connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
You can also connect the AC adapter using
the Everio dock connector. (p. 10)
•
The power/charge lamp blinks to indicate
charging has started.
•
When the lamp goes out, charging is
finished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camera.
1
battery pack.
To AC Outlet
(110V to 240V)
L
To detach the battery pack
Slide and hold BATT. (step 2), then
remove the battery pack.
L
To check the remaining battery power
See page 18.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.