Vogelzang International Mountaineer VG650ELG Owner's Manual page 9

Hide thumbs Also See for Mountaineer VG650ELG:
Table of Contents

Advertisement

ChImNEY CONNECTIONS continued ...
Fig. 13 - Chimney Construction Through Roof
Fig. 14 - Chimney Connection to Firebox
Through Masonry wall
VGZ-025 | 201110519.0
ManufaCturEd ChiMnEy
REFER TO CHIMNEY AND CHIMNEY
CONNECTOR MAKER'S INSTRUCTIONS FOR
INSTALLATION AND USE.
Use only 6" diameter listed chimney UL 103
HT. Chimney made to this listing is High Tempera-
ture rated to 2100 degrees Fahrenheit. Use chimney
from only one manufacturer. Never mix brands.
Carefully follow the chimney manufacturer's stated
requirements and clearances. Use the chimney
manufacturer's attic guards, roof supports, flashing
and fire stops when passing through a ceiling. Use a
listed thimble when passing through a combustible
wall. Do not use makeshift compromises during
installation. Never use a single-wall connection
pipe as a chimney!
When using a pre-existing chimney, have it's
condition and installation inspected before using.
Make sure that the chimney meets all of the UL
rating requirements listed above. Be aware that
not all manufactured chimney is of the UL 103
HT type.
NOTE: It is recommended that you contact a li-
censed heating and cooling contractor (consult your
local yellow pages) for chimney installation.
Manufactured chimney with the proper required
UL listing is available from most home centers,
hardware stores, and HVAC supply stores.
If you have access to the internet, you may
wish to view chimney manufacturers' informa-
tion on-line. See, www.duravent.com, www.
selkirkinc.com, or www.mtlfab.com.
VEntinG to ExistinG firEpLaCE
In some instances, people desire to convert an
existing fireplace for stove use. Usually, safe con-
nection to an existing masonry chimney requires
more work than using a prefabricated chimney.
The existing fireplace must be closed and sealed at
the damper with high-temperature caulk, ceramic
wool, or furnace cement. Prior to installation, clean
and inspect the existing flue and smoke shelf. In-
stallation should be designed so the system can be
dismantled for periodic cleaning and inspection.
Before conversion, make sure the existing chimney
is structurally sound, the chimney incorporates a
flue liner and make sure it is in good condition.
Vogelzang International Corp.
continued on next page
VG650ELG MountainEEr™ |
Page 9

Advertisement

Table of Contents
loading

Table of Contents