Page 2
STOVE TO AN ALUMINUM TYPE B GAS but it will not stand rough handling or abuse. When VENT. This is not safe. Use code-approved lined installing your stove, use care in handling. Page 2 | VG650ELG MOUNTAINEER™ www.vogelzang.com VGZ-025 | 20120424.1...
Page 3
30. DO NOT INSTALL IN A SLEEPING ROOM. BE CONSULTED IF YOU HAVE QUESTIONS 31. DO NOT INSTALL IN AN ALCOVE OR INSIDE A REGARDING THE INSTALLATION OF THIS FIREPLACE. SOLID FUEL BURNING APPLIANCE. Page 3 VGZ-025 | 20120424.1 Vogelzang VG650ELG MOUNTAINEER™ |...
Furnace Cement (manufacturer recommends Rutland Code 78 Safety Glasses or equivalent) Gloves CAUTION: STOVE IS HEAVY. MAKE SURE YOU HAVE ADEQUATE HELP AND USE PROPER LIFTING TECHNIQUES WHENEVER MOVING STOVE. FLUE COLLAR INSTALLATION continued on next page Page 4 | VG650ELG MOUNTAINEER™ www.vogelzang.com VGZ-025 | 20120424.1...
Fix the assembly to the back of the stove with the four screws provided. HE BLOWER ASSEMBLY IS INTENDED FOR USE ONLY WITH A STOVE THAT IS MARKED TO INDICATE SUCH USE. DO NOT ROUTE THE SUPPLY CORD NEAR OR ACROSS HOT SURFACES! Page 5 VGZ-025 | 20120424.1 Vogelzang VG650ELG MOUNTAINEER™ |...
26 MSG blue continued on next page Use 48 x 48 Standard Size Volgelzang Floor Protector VG650 Fig. 7 – TOP VIEW Minimum Clearance Dimensions from Combustible Surfaces Page 6 | VG650ELG MOUNTAINEER™ www.vogelzang.com VGZ-025 | 20120424.1...
Page 7
Fig. 8 – Top View Minimum Corner Clearances from Combustible Surfaces Fig. 9a – Front View Fig. 9b – Side View Minimum Clearance Dimensions Minimum Clearance Dimensions from Combustible Surfaces from Combustible Surfaces Page 7 VGZ-025 | 20120424.1 Vogelzang VG650ELG MOUNTAINEER™ |...
Page 8
NECTOR PIPE AS A CHIMNEY - A HOUSE FIRE ing. COULD RESULT. 4. The pipe cannot extend into the chimney flue (figure 10). CORRECT WRONG WRONG Fig. 10 – Stovepipe/Flue Connections Page 8 | VG650ELG MOUNTAINEER™ www.vogelzang.com VGZ-025 | 20120424.1...
4. Never use a chimney to ventilate a cellar or basement. 5. Contact your local building authority for approved methods of installation and any necessary permits and/or inspections. Fig. 12 - Chimney Construction Through Attic Space Page 9 VGZ-025 | 20120424.1 Vogelzang VG650ELG MOUNTAINEER™ |...
Page 10
Through Masonry Wall a chimney. If a chimney does not have a liner, or it is damaged, have it relined by a professional. DO NOT continued on next page Page 10 | VG650ELG MOUNTAINEER™ VGZ-025 | 20120424.1 www.vogelzang.com...
Positioning the center of the stove pipe entry into the chimney 24˝ below the ceiling FIG. 15 - Fireplace Conversion Page 11 VGZ-025 | 20120424.1 Vogelzang VG650ELG MOUNTAINEER™ |...
Page 12
24 gauge thickness. Fasteners used to secure chimney section shall not penetrate chimney flue liner. Page 12 | VG650ELG MOUNTAINEER™ www.vogelzang.com VGZ-025 | 20120424.1...
ADDING FUEL Add small amounts of fuel each hour or so instead of piling large quantities of fuel at one time. This will insure a more complete combustion continued on next page Page 13 VGZ-025 | 20120424.1 Vogelzang VG650ELG MOUNTAINEER™ |...
2. BURN ONLY SEASONED WOOD that has dried for at least one year. (<20% humidity by weight) 3. Burn hardwood rather than softwood. Hard- wood is denser or heavier wood and burns hotter. Page 14 | VG650ELG MOUNTAINEER™ www.vogelzang.com VGZ-025 | 20120424.1...
(less in the chimney will reverse direction. This is dense) air to rise. As the hot air rises within the known as “down drafting.” Page 15 VGZ-025 | 20120424.1 Vogelzang VG650ELG MOUNTAINEER™ |...
NOTE: A DRAFT READING OF 0.05 TO 0.06 W.C. 2. Remove screw and glass clips. (See parts list (WATER COLUMN) IS REQUIRED FOR PROPER and diagram.) BURNING OF THIS STOVE. Page 16 | VG650ELG MOUNTAINEER™ VGZ-025 | 20120424.1 www.vogelzang.com...
Page 17
After extensive use, the gasket material which provides glass and door seal may lose it’s resiliency WIRING DIAGRAM - VG650ELG MOUNTAINEER STOVE CAUTION: MOVING PARTS CAN CAUSE DANGER: SHOCK HAZARD. DISCONNECT INJURY. DO NOT OPERATE WITH COVER POWER SOURCE BEFORE INSTALLATION REMOVED.
Page 18
ORDERING PARTS - VG650ELG MOUNTAINEER STOVE OR ERIN ARTS MOUNTAINEER STO E When ordering missing or replacement parts, always give the Model Number of the stove, Part Number, and Part Description. Use the illustrations and part lists provided to identify parts.
Page 19
ORDERING PARTS - VG650ELG MOUNTAINEER STOVE When ordering missing or replacement parts, always give the Model Number of the stove, Part Number, and Part Description. Use the illustrations and part lists provided to identify parts. Glass replacement instructions for model VG650ELG WARNING: Do not use substitute materials.
Page 20
Rbrick + Rmin.brd = 0.80 + 0.431 = 1.231 = Rsystem Step 4: Compare Rsystem to Rspecs Rsystem = 1.231 is larger than Rspecs of 0.893. System R-value exceeds the required specifications and therefore is an acceptable alternative. Page 20 | VG650ELG MOUNTAINEER™ VGZ-025 | 20120424.1 www.vogelzang.com...
Need help?
Do you have a question about the MOUNTAINEER VG650ELG and is the answer not in the manual?
Questions and answers