Advertisement
3.
Choose
the proper window
location.
Choose a window
that allows the cooled
air to flow
freely and directly
into room(s) you wish to cool.
Remember,
it is difficult to move air around corners.
Also, choose
a window
that is within 6 feet of an
electrical
outlet. (See Meeting
Electrical
RequirementstReceptacle
wiring needs.)
Do not
use an extension
cord.
Installing
Unit in a Sliding Window
1. Attach support
brace
to platform
as shown.
Use adjustment
bolt and hex flange nut to complete
assembly.
Choose
slot and adjustment
bolt hole
locations
that will create a 45 degree angle between
platform
and support
brace. Try assembly
in the
window
to determine
if platform
will rest properly,
and
allow proper slope (3t16-inch
lower on outside).
NOTE:
If you are planning
to use a siding-
protection
board (see Step 5) on the outside
of your
house, hold board in place when testing assembly
in
window.
2. Measure,
and lightly
mark a line 8-11/16
inches
from
window
jamb.
NOTE:
If any sash stop protrudes
more than 1
inch from the side window jambs,
the 8-11116-inch
measurement
must be increased
accordingly.
Screen
and storm window
frames
may also require
adjustments
to the measurement.
3. Center
platform
assembly
on the line with inside
platform
tab pressed
against
inside edge of window
track. Using the holes in the platform
as a guide,
mark and drill two 9164-inch diameter
holes. Drill
holes in either track or stool.
Property
Damage
Hazard-Failure
to adhere
to
the following
precaution
could
result
in
damage
to window
or air conditioner.
Be sure wood stool or window
track is securely
attached
to the building
construction.
Use longer
screws in sub-framing
if necessary.
V2' (6mm) HEX FLANGE NUT
8 "/,_ !nches
Center platform
assembly
on the
line with platform
tab pressed
against
window
track
Platform Assembly
A[te_nate screw Focation
(depending on the stool depth /
(continued
4
Advertisement
