Table of Contents
Advertisement
Installation Instructions
(continued)
Installation in a double-hung sash window
1. Cut the foam seals(adhesive type) to the proper lengths and attach them
to the window and stool. (Fig. 12)
2. Open the window sash and place the window slider kit on the window stool
(Fig. 13). Attach the window slider kit to the window stool. Adjust the length
of the window slider kit according to the width of window. Screw down the
two screws on the window slider kit. See Fig.13. Cut the adjustable window
slider kit if the width of window is less than 26.6 inches (Fig. 14).
3. Close the window sash securely against the window slider kit. (Fig. 15)
4. Drive two 1/2" screws to secure the window slider kit to the window sash.
(FIG. 15)
5. Secure the window slider kit to the window stool
A: For wooden windows: Use 3/4" screws for securing.
B: For Vinyl-Clad windows: Use
6.
To secure lower sash in place, attach right angle sash lock with
NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad
windows, so you can use lock by window itself.
7. Cut the foam seal to an appropriate length and seal the open gap
between the top window sash and outer window sash, as shown in Fig.17.
Window slider kit
hex head cap screws
Window stool
Installation in a sliding sash window
1. Cut the foam seals(adhesive type) to the proper lengths and attach them
to the window frame. See Fig.18.
2. Open the window sash and place the window slider kit on the window stool.
See Fig.19. Attach the window slider kit to the window stool. Adjust the
length of the window slider kit according to the height of window. Screw
down the two screws on the window slider kit. See Fig.19. Cut the adjustable
window slider kit if the height of window is less than 26.6 inches (Fig. 14).
3. Close the sliding sash securely against the window slider kit. (Fig. 20)
4. Drive two 1/2" screws to secure the window slider kit to the window sash.
(Fig. 20)
5. Drive two 3/4" screws to secure the window slider kit to the window stool.
(Fig. 20)
6. Cut the foam seal to an appropriate length and seal the open gap
between the sliding sash and outer window sash, as shown in Fig.21.
7. To secure the sliding sash in place, attach right angle sash lock with 1/2"
(12.7mm) screw as shown.(Fig.22)
Foam seal
2009 Electrolux Home Products, Inc.
(FIG.
Fig. 15
Fig. 21
Installation Instructions
15):
for securing.
Fig. 16
Foam seal
Fig. 17
Fig. 22
screws
26.6"~48.5"
Window stool
Cut this side to fit your window
Foam seal
(adhesive type)
Window stool
Window slider kit
screws
26.6"~48.5"
Window slider kit
Window stool
All rights reserved.
Foam seal A
(adhesive type)
Fig. 12
Window slider kit
Fig. 13
Fig. 14
Fig. 18
Fig. 19
Fig. 20
7
Advertisement
Table of Contents
