Table of Contents
Advertisement
Guide de l'utilisateur
PRINCIPALES CARACTÉRISTIQUES
DU H2O MOP
A) Poignée
B) Gâchette
C) Poignée de transport
D) Réserv o i r
E) Filtre
F) Corps
G) Vo y a n t
H) Enrouleur du cordon
d'alimentation
S
I)
Cordon d'alimentation
J)
Tête
K) Lingette micro f i b re
(ou lingette jetable -
N
disponible en option)
L) Patin
M) Godet de mesure
N) Grande vis
O) Petite vis
P) 2 joints noirs en caoutchouc
R) 2 rondelles blanches
S) Anneau de la poignée
O
L
M
Les informations suivantes sont fournies pour les réparations, uniquement par un électricien qualifié :
110~120V, 60HZ, 1500W
220~230V, 50/60HZ, 1500W
Cet appareil doit être mis à la terre. Lors du branchement de l'appareil, n'utilisez que le type de prise adapté, ne
tentez pas de supprimer la fonction de mise à la terre.
R
9
U S E R ' S G U I D E
15) When the H2O Mop stops emitting steam, this will occur after approximately 20 minutes of use, turn off the
H2O Mop and simply remove the Water tank, refill, and then again turn on and continue cleaning.
WARNING: NEVER run the H2O Mop without water. NEVER direct steam at any person or animal. Use the H2O
Mop on sealed hard floor only.
16) When you finish your cleaning, unplug Power cord from outlet, empty the Water tank, carefully remove the
Cloth Pad from the head, wind Power Cord around the Cord Wrap and store it upright in a dry area or hang by the
storage hook.
C A U T I O N : The Cloth Pad may be very hot.
Not for space heating purpose.
CLEANING AND MAINTENANCE
CAUTION: Prior to cleaning or maintenance isolate the unit by removing the cord from the power socket. Do not
immerse the unit in water.
1) Microfiber Cloth Pad can be machine washed in hot water and tumbled dry.
P
2) Wipe the steamer with a soft cloth.
The H2O Mop should only be used with its own specially developed floor cloths and Filter (spare Cloth Pads and
Filters are available from your retailer).
TROUBLESHOOTING GUIDE
CAUTION: Prior to troubleshooting isolate the unit by removing the cord from the power socket.
Problem
LED is not on.
The H2O Mop will not produce steam.
Pale residue left on the floor.
Solution
Ensure the H2O Mop power cord is correctly
plugged into power outlet and power trigger is
turned on. Ensure circuit breaker is operational.
Try operating the H2O Mop from another power
outlet.
Ensure the water tank has correct level of water.
Caused by leaving the H2O Mop in the same
position for too long. Can be removed with
household white vinegar or a decalcifying product.
Alternatively reheat the area for one minute and
residue should be removed.
CAUTION: Do not overheat area.
6
Hide quick links:
Advertisement
Table of Contents
