Page 1
Installation Instructions Epicure®Wall Mount Range Hood with Remote Blower For use with models: EHR30, EHR36, EHR42, EHR48, EHR54 APPROVED FOR USE WITH ALL DACOR ® RANGES AND COOKTOPS. TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI/UL STANDARD FOR ELECTRIC FANS AND CAN/CSA-C22.2...
Page 2
Keep these installation instructions for future reference and the local electrical inspector's use. If You Need Help... If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under war- ranty call the Dacor Distinctive Service line.
WARNING ating this or any other appliance. Hazards 0r Unsafe practices that COULD result in severe • Always contact the Dacor Customer Service Team personal injury or death. about problems and conditions that you don't under- stand. CAUTION...
A qualified service technician should perform all other service. Contact the nearest Dacor authorized service representative at (800) 793-0093, or at www.Dacor.com for examination, repair or adjust- ment • Keep all packaging materials away from children. Plastic bags can cause suffocation.
EHR4218 Lights 120 Vac, 75 W halogen 51 Ibs. (23 kg) EHR4812 52 Ibs. (24 kg) Model Specific EHR4818 59 Ibs. (27 kg) Model Number EHR5418 66 Ibs. (30 kg) EHR48 EHR30 EHR42 EHR54 EHR36 Lights Filters Exhaust Outputs _mCD_...
Page 6
Dimensions Tolerances: +1/16",-0 (1.6 mm,-0), unless otherwise stated. NOTE: The exhaust duct(s) and electrical wiring can be connected from either the top or the back of the hood. Dual exhaust models* Single exhaust models** Standard 8" duct connection Standard 8" duct connection Front of hood Electrical access holes...
(1.9 cm) 7 for more information Parts List Hood assembly with filters (size and style varies with model) Light replacement tool 2 temporary mounting brackets iterature Temporary mounting hardware Light bulbs (quantity varies with model) Dacor Stainless Steel Cleaner _mCD_...
WARNING for I observe all g0verning c0des and ordinances during planning and installationl Contact y0ur local building department further informati0nl Cabinet Layout IMPORTANT See the diagram for minimum installed distance from WARNING the hood t0 the co0ktop surfacel The minimum specified distance maybe higher for the particular range or To reduce the risk of personal injury caused by reaching cooktop in use: Check the manufacturers...
Page 9
The ventilation system consists of hood and a single Blower remote or single in-line blower. • A Dacor remote or in-line blower must be installed for Conduit the hood to operate properly. Only one blower shall be installed..Remote...
Keep turns as far away from the hood exhaust as pos- Duct Work Equivalent Lengths sible, and as much space between bends as possible. EQUIVALENT LENGTHS For best performance, use round duct instead of rect- Piece Subtract Piece Subtract angular, especially when elbows are required. 8"...
Electrical Service Installation Back wall WARNING The e!ectric service to the range hood sh0u nsta e d only by a licensed electrician....Install a junction box in the vicinity of the hood electri- cal access holes according to local codes. Install it either behind or above the hood.
Page 12
On dual exhaust models, the two 8" exhausts may be collar(s) must be moved to the rear before hanging the merged into one 10" duct using Dacor transition kit AHT10. hood. Install the transition before installing the hood on the wall. It connects to the hood on the top or rear, depending on the Place the hood assembly on a large flat surface.
12" high models with rear exhaust: Installing the AHT1 0 Transition" Center the transition over the duct collars while resting the Top exhaust unmodified edge on the top of the hood. Fasten in place models and 18" using sheet metal screws (not included). Seal the base of high models with of the transition with duct tape.
Hood Hanging the Range Reattach the hood to the temporary mounting brackets. Lift the hood into its final position and fasten it in place. WARNING back and top of the hood into the studs, mounting Insert the fasteners through the mounting slots in the Hanging the range hood requires _o people: Do not blocks or anchors.
Page 15
Connect the wiring to the remote/in-line blower and the power supply line from the junction box as shown. To remote/ Neutral in-line blower Ground To junction Hood Power Terminals Connect the hood wiring to an electrical junction box on a dedicated circuit. See page 6 for specifications. Connect it according to the 3-Wire Connection Junction Box method shown or External Ground...
To house circuit breaker Separate No. 10 (minimum) panel or fuse box copper ground wire Wire Nut, Meter 3 places WHITE WHITE No. 4 copper wire GREEN GREEN Junction Box UL/CSA approved Insulated Pipe Jumper NEMA strain relief To range hood (if necessary) WARNING •...
Check the electrical connections to ensure that the installation has been completed correctly. Repeat the above test. If the hood still does not work, contact Dacor Distinctive Service at (877) 337-3226. Do not attempt to repair the appliance yourself. If you need service, be sure to have the model and serial numbers available when you call.