Advertisement
b
Steps of using the operation buttons and
description of the steps
9
10
7
8
5
6
3
4
1
2
1.Push "power" button to switch on the power
2.Push "program" button to select suitable
full-auto program
After the power is switched on, "standard" is automatically set. To select other full-auto program, please
push the "program" button till the corresponding indicator is on. Refer to the "Program button" on Page 11.
E.g. Set to "Quick wash" program for small quantity of laundries with light soil.
3 Push "Process" button to select suitable procedure program
Attention
Even there's no water in the tub, a certain period is required before spin starting.
Separate the laundries that are not colorfast from other laundries in washing.
The soak procedure can work in cooperation with automatic programs like standard. There is
intermittent pulsator stirring during soak.
After the machine starts operation, you can only set the program and procedure during washing,
and can not make setting in other cases.
12
Standard
Soak
Heavy
Wash
Soft wash
Rinse
Quick wash
Spin
Tub dry
5
How to change the direction of the drain hose
1.Dismantle the rear cover of the washing machine.
3.Dismantle the drain outlet protecting cover at the other side,
(the way is the same as the drain bushing),then install the drain
2.Put down the drain hose
Take off the drain hose
frame as indicated in Figure 1.Take the drain hose into
the cabinet
then nip the drain fixing clamp to make
it deviated from the clip the other hand is used to put
down the drain bushing
as indicated in Figure 2 3.
drain outlet protecting
Drain hose
Drain hose support
Drain bushing
Cabinet
Figure 2
Figure 1
Inner
Outer
Push
Drain bushing
Take down
Drain hose fixing
clamp
Push
Figure 3
Remarks: in order to make sure of the correct of installation, it is suggested to change the direction of the drain hose
with our company serviceman .
Usage the drain hose
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than 10cm,
or the drainage will not be smooth, and cost such long
time that the machine may stop at mid way.
2.Do not step on or press the drain hose.
3.
If the drain hose is too long, cut it at mid point. To make
smooth drainage, cut the front end of the hose slantingly.
bushing, as indicated in Figure 4.
4.Extend the drain hose from the other side. Fix the drain hose
with drain hose frame onto the cabinet, as indicated in Figure 5.
cover
Figure 4
Figure 5
Drain bushing
5.Install the drain outlet protecting cover to the other side,
as indicated in Figure 6
Figure 6
4.If extra drain hose is needed, please make separate
purchase. The inner diameter of the extra hose shall
not less than 30mm, and the length shall not exceed
1.5m.
5.If the extra hose is too long, cut it either at A or at B.
5
Advertisement
