Do Not Install Your Washer - Electrolux SATF7000FS1 Installation Instructions Manual

Clearance requirements
DO NOT INSTALL YOUR WASHER:
1. In an area exposed to dripping water or outside weather
conditions. The ambient temperature should never be be-
low 60 ° F (15.6 ° C) to maximize detergent effectiveness
2. In an area (garage or garage-type building) where gaso-
line or other flammables (including automobiles) are kept
or stored.
3. On carpet. Floor MUST be solid with a maximum slope
of 1 inch (2.54 cm). To minimize vibration or movement,
reinforcement of the floor may be necessary.
Installation in a Recess or Closet
If washer and dryer are installed in the same closet, door
ventilation is required: A minimum of 120 square inches
(774.2 cm 2) of opening, equally divided at the top and
bottom of the door, is required. Louvered openings should
be located 3 inches (7.6 cm) from bottom and top of door.
Air openings are required to be unobstructed when a door
is installed. A Iouvered door with equivalent air openings for
the full length of the door is acceptable.
f
60 sq. in.
(387.1 cm 2}
______
f
60 sq. in.
(387.1cm 2)
closet door
MINIMUM INSTALLATIONCLEARANCES- Inches (cm)
SIDES REAR TOP FRONT
Alcove 0" (0 cm) 0" (0 cm) 0" (0 cm) n/a
Under-
0" (0 cm) 0" (0 cm) 0" (0 cm) 1" (2.5 cm)
Counter
Closet 0" (0 cm) 0" (0 cm) 16" (40.5 cm) 1" (2.5 cm)
Ii
II
10
0" ====ll_-i i_=lF-===
(Ocm)
[
" " O" _
(0cm)
/
It
It
II
1" _""_01 _l==m"
(2.5cm) I I
ii
ii
II
(Ocm) al
f_
--i --i -- [ J