Something Not Working - Electrolux EWF 887 Instruction Booklet

Table of Contents

Advertisement

Available languages

Available languages

IM_EWF887.qxp
25-10-2005
9:47

Something not working?

Problems which you can resolve yourself, before calling the After Sales Service.
During machine operation it is possible that the End light starts to flash:
4 flashes= the door has not been closed
2 flashes= the machine does not empty
1 flash= the machine does not fill.
Once the problem has been eliminated, press the Start/Pause button to restart the programme. If after all
checks, the problem persists, contact your local Service Centre.
• The machine does not start up:
• The machine does not fill:
• The machine fills then empties
immediately:
• The machine does not empty and/or
does not spin:
• There is water on the floor:
• Unsatisfactory washing results:
Pagina 19
Problem
Possible cause
• The door is not firmly closed.
• The machine is not plugged in or there is no power
at the socket.
• The main fuse or the fuse in the plug has blown.
• The programme selector dial is not positioned
correctly and the Start/Pause button has not been
depressed.
• The water tap is closed.
• The inlet hose is squashed or kinked.
• The filter in the inlet hose is blocked.
• The door is not properly closed.
• The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage" section.
• The drain hose is squashed or kinked.
• The Rinse Hold option has been selected.
• The drain pump is clogged.
• The laundry is not evenly distributed in the drum.
• Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• The cap on the emergency emptying hose has not
been replaced after cleaning the filter.
• The pump has not been fully screwed in after
cleaning.
• Too little or too much detergent has been used.
• An unsuitable detergent has been used.
• Stubborn stains have not been treated prior to
washing.
• The correct programme/temperature was not
selected.
• Excessive laundry load.
19

Advertisement

Table of Contents
loading

Table of Contents