Routing Page - TC Electronic FireworX User Manual

EFFECTS SETUP
The Routing page
The Routing page is where you set up the order of the effect blocks, the sub-algorithm in each block, the left/right setup of each block and
the Mute mode of each block.
The full Routing grid can be up to 8 by 8 spaces, and you can place any effect anywhere in the grid, however, the FireworX will not scroll
through the last row unless a block is placed closer than two rows away. The size of the grid can be changed in the Layout page.
Maximum number of inserted blocks
Due to the dynamic processing power structure of the FireworX, you can keep adding new blocks to the Routing until all power is used.
The total amount of simultaneous blocks depends on the power taken up by the individual blocks. The power allocation is showed in the Tool
The Routing page
Double click on the
block Mute key of the
effect you want to
insert and dial Value
wheel to select sub-
algorithm.
Press Enter to insert.
Block name and
sub-algorithm
The sub-algorithms of the blocks
All effect blocks contain a number of sub-algorithms. To change
the sub-algorithm of a block, place the cursor on the block (while
standing in the Routing page) by dialing the Parameter wheel,
dial the Value wheel to select the new sub-algorithm and press
Enter to confirm.
Here is a complete list of sub-algorithms in the Effect blocks:
22
Effects
Empty spaces
Selected
DYNAMIC
Expander/Gate
Soft Compressor
Hard Comp/Limiter
FORMANT
Formant
VOCODE
Vocoder
Ring Mod. Internal
Ring Mod. External
PITCH
Single Voice
Dual Voice
Dial Parameter wheel
to select effect and
press Enter to set up
block I/O
Cursor position
FILTERS
Resonance
Bandpass
Phaser
Resonator
Resochord
DISTORT
Drive
Cruncher
SYNTH
Curve Generator
Chaos generator
Noise Generator