Setting The Sleep Timer; Learning - X10 UR24A Owner's Manual

S S
ETTING THE
The Sleep Timer automatically turns off
the TV after the time you set. Press the TV
button, then follow the instructions below
to set the Sleep Timer:
1. Press and hold
TIMER until the LED
indicator lights
steadily. Release
TIMER button.
2. Use the number
buttons to enter the
sleep time required
(1 to 99 minutes).
3. Press ENTER to
confirm the setting.
Note: Make sure you leave the remote
pointing at the TV to ensure it turns off the
TV at the time you set.
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com
T
LEEP IMER
28
L
EARNING
Your UR24A Learning SuperRemote has
the codes for most TVs, VCRs, etc. in its
code library. However, if the code for
your particular device is not found in the
library, you can learn these codes from
your existing remote. Or if you find a
code from the tables in this manual that
"almost" matches your device, but a few
buttons are missing, you can learn just
those buttons.
1. Point your existing
remote at the
SuperRemote with
a distance of about
2 inches between
the remotes.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
the Setup button.
3. Press the mode
button that matches
the equipment you
want to learn. The
LED blinks once.
4. Press and release
the LEARN button.
The LED blinks
once.
5. Press and release
the button on the
SuperRemote that
you want to teach.
The LED blinks
once. (Press shift
first to learn a
shifted function).
See notes on pages 30 and 31.
29