Using Aux; To Control; A Second Tv, Vcr, Cableb; Satellite Receiver - X10 UR24A Owner's Manual

STS .................................................................. 013
SYLVANIA ......................................................... 019
SYMPHONIC .................................................... 062
.............................................................................
TEAC ............................ 029,042,052,062,063,064
TECHNICS .......................................... 069,086,089
THETA DIGITAL ................................................... 084
TOSHIBA .......................................................... 074
.............................................................................
VECTOR RESEARCH .................................... 017,032
VICTOR ............................................................ 035
.............................................................................
YAMAHA ..................................... 018,065,066,077
HOME AUTOMATION CODES
.............................................................................
X-10 HOME AUTOMATION (RF) ........................... 013
X-10 HOME AUTOMATION (IR543)...................... 014
GE HOMEMINDER ............................................ 015
.............................................................................
U AUX
SING TO CONTROL A
S TV, VCR, C
ECOND
S R
ATELLITE ECEIVER
The AUX button is normally used to
control an audio component, but it can
also be configured to control a second
TV, VCR, cable box or satellite receiver.
1. Turn on the
equipment you
want to control.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3. Press either AUX
button, then press
the mode button
that matches the
equipment you
want to control (TV,
VCR, CBL, SAT).
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com
B
ABLE OX OR
24
4. Press and release
the mode button
that matches the
A/V equipment you
want to control. The
LED blinks once.
5. Enter the 3 digit
Code from the
Library Code
Tables. The LED
turns off after the
last digit entered.
6. Point the remote at
your audio
component and
press the POWER
button. Your audio
component should
turn off.
7. Turn your audio
component on and
press CH +. If it
responds, setup is
complete.
Notes:
If your audio/video component does
not respond, try the other codes for your
brand. If it still doesn't respond, try the
Code Search method on page 26.
If the LED blinks rapidly when you
enter the code, you may have entered
an invalid code. Recheck the code in the
code list and try again.
25