Installing Batteries - Treasure Cove Professional 9700 Owner's Manual

4. Unscrew the knob on the search coil and remove the knob connector.
Insert the stem and align the holes on the search coil bracket and the stem.
Push the connector through the holes and tighten the knob.
5. Wind the search coil cable around the stem. Leave enough slack in the
cable.
6. Insert the search coil's plug into the matching jack on the detector's control
housing.
Caution:
The search coil's plug fits into the jack only one way. Do not force the plug
or you could damage it.
To disconnect the cable, pull out the plug. Do not pull on the cable.
7. Adjust the coil by loosening then tightening the knob on the coil.
Note: Do not overtighten the knob, nor use tools to tighten it.
8. Insert the arm support into the end of the stem and tighten the fixing
screw.
knob connector
stem

INSTALLING BATTERIES

Your metal detector requires two 9V batteries (not supplied).
searchcoil
knob
locknut
cable
arm support
3