Related Manuals for Treasure Cove Fortune Finder 1020
Summary of Contents for Treasure Cove Fortune Finder 1020
- Page 1 Treasure Cove Metal Detector Fortune Finder 1020 OWNER’S MANUAL www.Treasure-Cove.com 805-658-2328...
- Page 2 With your 1020 metal detector, you can hunt for coins, relics, jewelry, gold, and silver just about anywhere, including lawns, snows, mountains and etc. The detector is versatile and easy to use. Four operating modes: DISCRIMINATION --- in this mode, the unit comes with auto ground balance. This mode can facilitate you to search for and discriminate the target type based on the different tone for different metal target.
-
Page 3: Assembling The Detector
· Arm Support---lets you carry and operate your detector comfortably. · Power---Your metal detector requires two 9-volt alkaline batteries (not supplied). The built in insolating circuit can avoid wrong battery connection and prolong the battery life. PREPARATION ASSEMBLING THE DETECTOR Assembling your detector is easy and requires no special tools. -
Page 4: Installing The Batteries
Caution: The search coil’s plug fits into the jack only one way. Do not force the plug or you could damage it. Don’t pull the cable if you want to pull out the plug from the jack. 4. Rotate the stem’s lock nut clockwise to loosen it. 5. -
Page 5: Using Headphones
· If you don’t plan to use the unit for a week or more, remove the batteries. Batteries can leak chemicals that can destroy electronic parts. Warning: · Dispose old batteries promptly and properly. Never bury or burn them. USING HEADPHONES 1. -
Page 6: Mode Switch
SENS--- sensitivity control and also used as power switch. Fully counter-clockwise rotate the switch to OFF to turn off the power. Rotate it clockwise away from OFF to turn on the power. When you rotate the SENS from 0 to 10, the sensitivity is gradually increased. 0 is the lowest position for SENS;... -
Page 7: Operation
OPERATION Your 1020 has four operation modes: DISC,TONE ,ALL METAL and TARGET. DISC, TONE and ALL METAL are motion modes. You have to move the coil to search for target. While TARGET is a non-motion mode. When searching, generally set operation mode to ALL METAL and SENS to less 10. - Page 8 again. Repeat the above steps until you find the target. After you find the target, set mode to DISC or TONE to determine which kind of metal the target is. 3. DISC—in this mode, unit discriminates the metal type with different tones, say short, long or silence.
-
Page 9: Care And Maintenance
When searching in trash area, it’s better to set the “DISC” to 5 position, so that the unit can reject most of invaluable metals such as nails and small trashy iron. Move away any metal digging tool when searching. In “TARGET ” mode, the unit can detect any type of metal. So it is very likely to meet interference, if you search for small target near a large metal. - Page 10 it looking new. Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the detector.
Need help?
Do you have a question about the Fortune Finder 1020 and is the answer not in the manual?
Questions and answers