Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Treasure Cove Fast Action TC-1018
Summary of Contents for Treasure Cove Fast Action TC-1018
- Page 1 OWNER’S MANUAL Please read before using this equipment Treasure Cove TC-1018 Fast Action Sand & Surf Metal Detector www.treasure-cove.com/support Register your purchase for warranty coverage Questions that cannot be answered by this manual. Replacement parts...
- Page 2 FEATURES With your Fast Action TC-1018 Metal Detector, you can hunt for coins, relics, jewelry, gold, and silver just about anywhere. This metal detector is versatile and easy to use. The detector’s features include: Three Operation Modes: ALL METAL, DISC, PINPOINT ALL METAL—lets you search for all kinds of metal with auto ground...
-
Page 3: Assembling The Detector
PREPARATION ASSEMBLING THE DETECTOR Assembling the detector is easy and requires no special tools. Just follow these steps. 1. Unscrew the knobs on the search coil and remove the knobs and the connector. Insert the smaller stem and align the holes on the search coil bracket and the stem. -
Page 4: Adjusting The Search Coil
5. Insert the search coil cable plug into the five pin jack on the back control box’s housing. 6. Lengthen or shorten the stem, so when you stand upright with the detector in your hand, the search coil is level with and about 1~5cm above the ground. -
Page 5: Installing Batteries
INSTALLING BATTERIES You need two 9V alkaline batteries to power your detector. Cautions: Use only fresh battery of the required size and recommended type. If the detector is on, turn the power switch (on the control panel) to POWER OFF . Press on the battery compartment cover and slide the cover off in the direction of the arrow. -
Page 6: Listening Safely
USING HEADPHONES/EAR BUDS You can connect a pair of stereo headphones (not supplied) to the detector so you can listen to it privately. Using headphones also saves battery power and makes it easier to identify subtle changes in the sounds you hear, for better detection results. To connect headphones to the detector, insert the headphones’... - Page 7 FUNCTIONS AND INDICATORS 1. A QUICK LOOK AT THE DETECTOR a. DISC—Rotate the control clockwise away from ALL METAL to get DISC mode. The DISC mode comes with auto ground balance. Rotate the control slowly and clockwise to eliminate different trash objects. Rotate the control counter clockwise to the end to get ALL METAL mode.
-
Page 8: Testing And Using The Detector
accurately. In ALL METAL mode, when you find metal object, you can press to pinpoint the target. Hold the search coil 50cm or more away from the ground. Press and hold down this button. Sweep the search coil over the sound area and release the button when you hear a sound. After about 1~2 seconds, hold down the red button again, the sound disappears. - Page 9 determine which kind of metal the target is. Slowly rotate the DISC control clockwise away from ALL METAL until the unit does not sound or sounds short tone. You can identify what kind of metal is detected according to the setting position of DISC. Here is a quick reference for some typical settings so you know what kind of metal is rejected depending on the DISC setting.
- Page 10 Move away any metal digging tool when searching. Sensitivity level is generally in contradiction with that of the Discrimination. The higher the sensitivity level is, the worse discrimination will be. But you can lower the sensitivity to have better discrimination.
-
Page 11: Year Limited Warranty
(10) years from the date of purchase. In the event that a Treasure Cove product does not conform as warranted, the purchaser's sole remedy shall be limited to repair or replacement of all or any part of the product that does not conform. - Page 12 To make a claim under this limited warranty, contact your original distributor promptly (but in no event more than ten (10) years after the date of your purchase), and if you need other assistance, contact: Treasure Cove c/o Warranty Service 2269 Chestnut Street #333...