Tv Output Signal; Real Time Clock - Toshiba M50 User Manual

TV output signal

Problem
Display on TV is poor
No display
If you turn the computer off in Standby Mode while the display is on a TV,
the computer will select either the internal LCD or an external computer
CRT as the display device the next time it is switched on.
Standby/Hibernation
Problem
The system will not
enter Standby/
Hibernation

Real Time Clock

Problem
The following
message is displayed
on the LCD:
RTC battery is low or
CMOS checksum is
inconsistent. Press
[F2] key to set Date/
Time.
User's Manual
Procedure
Make sure the TV type is correct for your area:
NTSC (US) or PAL (Europe).
Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5,
If problems persist, contact your dealer.
Procedure
®
Is Windows Media Player open? The system
might not enter Standby/Hibernation, if
®
Windows Media Player is either playing a
selection or finished playing a selection. Close
®
Windows Media Player before you select
Standby/Hibernation.
If problems persist, contact your dealer.
Procedure
The RTC battery charge has become exhausted,
you should set the date and time in within the
BIOS setup screen through the following steps:
1. Press [F1] key. BIOS setup will boot up.
2. Press [F2] to set the date in [System Date].
3. Press [F2] to set the time in [System Time].
Troubleshooting
The Keyboard.
9-14