Remote Control Battery Installation; General Control - Sharp XL-E1H Operation Manual

Remote control - battery installation
Note:
Before using remote control, please remove plastic shield
at battery holder.
1�
Whilst pushing the locking tab towards the center
of the remote control, slide out the battery holder.
Remote
control
Battery holder
2�
Remove the old battery from the battery holder,
insert the new battery and then slide the battery
holder back into the remote control.
Battery holder
Polarity
(+) symbol
Battery type
Locking tab

General control

To turn the power on
■
Function Main unit
Power on/
off
Back of remote
Plastic
shield
Locking tab
Positive (+)
side up
Remote
Operation
control
Press to turn the
power on or to
go to stand-by
mode.
Precautions for battery use:
Remove the battery if the unit will not be used for long
periods of time. This will prevent potential damage due to
battery leakage.
Caution:
Do not use rechargeable battery (nickel-cadmium
●
battery, etc.).
control
Danger of explosion if battery is incorrectly replaced.
●
Replace only with the same or equivalent type.
●
Batteries (battery pack or battery installed) shall not
●
be exposed to excessive heat such as sunshine, fire
or the like.
Installing the battery incorrectly may cause the unit to
●
malfunction.
Notes concerning use:
Replace the battery if the operating distance is
●
reduced or if the operation becomes erratic. Purchase
"CR 2025", coin lithium battery.
Periodically clean the transmitter on the remote control
●
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may
●
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
Keep the remote control away from moisture, heat,
●
shock, and vibrations.
Volume auto set-in
■
If you turn off and on the main unit with volume set to
●
16 or higher, the volume will start at 16.
If you turn the unit off then on again with the volume
●
level set to less than 16, it will turn on again at the
level set.
Volume control
■
Press the VOLUME +/– button to increase or decrease the
volume.
Extra bass control (X-BASS)
■
When the X-BASS button is pressed, the unit will enter the
extra bass mode which emphasises the bass frequencies
and "X-BASS" indicator will light up. To cancel the extra
bass mode, press the X-BASS button again.
Auto power off function
■
The main unit will enter the stand-by mode after 15 minutes
of inactivity during:
CD/USB: In the stop or pause mode.
TUNER: No reception of broadcast signal.
AUDIO IN: No detection of input signal.
Muting
■
The volume is muted temporarily when pressing the
MUTE button on the remote control. Press again to restore
the volume.
E-