Maintenance - Sharp XL-E1H Operation Manual

Troubleshooting chart (continued)
USB
■
Symptom
Device cannot be
●
detected.
Playback does not
●
start.
Wrong time display.
●
Wrong file name
●
display.
Condensation
■
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation
inside the cabinet (CD pickup, etc.) or on the transmitter
on the remote control. Condensation can cause the unit
to malfunction. If this happens, leave the power on with no
disc in the unit until normal playback is possible (about 1
hour). Wipe off any condensation on the transmitter with a
soft cloth before operating the unit.
Before transporting the unit
■
Remove all CDs from the unit. Make sure there is no CD
in the disc tray. Then, set the unit to the power stand-by
mode. Carrying the unit with discs left inside can damage
the unit.
If problem occurs
■
When this product is subjected to strong external
interference (mechanical shock, excessive static electricity,
abnormal supply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1�
Set the unit to the stand-by mode and turn the
power on again.
2�
If the unit is not restored in the previous operation,
unplug and plug in the unit again, and then turn
the power on.
Note:
If neither operation above restores the unit, clear all the
memory by resetting it.
Possible cause
Is there any MP3/WMA file
●
available?
Is the device properly
●
connected?
Is it an MTP device?
●
Does the device contain
●
AAC file only?
Is it a copyright protected
●
WMA file?
Is it a false MP3 file?
●
Is Variable Bitrate
●
being played back?
Is the File Name written
●
in Chinese or Japanese
characters?
Factory reset, clearing all memory
■
1�
Press the ON/STAND-BY button to enter the power
stand-by mode.
2�
Press down the VOLUME + button and
on main unit until "CLR ALL" appears.
Caution:
file
This operation will erase all data stored in memory including
clock, timer settings, tuner preset, and CD program.
Care of compact discs
■
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on
the disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
Do not write on either side of the disc, particularly the
●
non-label side from which signals are read. Do not
mark this surface.
Keep your discs away from direct sunlight, heat, and
●
excessive moisture.
Always hold the CDs by the edges. Fingerprints, dirt,
●
or water on the CDs can cause noise or mistracking.
If a CD is dirty or does not play properly, clean it with
a soft, dry cloth, wiping straight out from the centre,
along the radius.
NO

Maintenance

Cleaning the cabinet
■
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint thinner,
●
etc.). It may damage the cabinet.
Do not apply oil to the inside of the unit. It may cause
●
malfunctions.
E-1
button
YES
Correct