Enhancing Your System; Troubleshooting Chart - Sharp XL-E1H Operation Manual

Enhancing your system

The connection cord is not included. Purchase a
commercially available cord as shown below.
Portable audio
player, etc.
Listening to the playback sounds of
■
portable audio player, etc.
1�
Use a connection lead to connect the portable
audio player etc. to the AUDIO IN socket.
2�
Press the ON/STAND-BY button to turn the power
on.
�
Press the AUDIO IN button on the remote control
or FUNCTION button repeatedly on main unit to
select AUDIO IN function.
�
Play the connected equipment. If volume level of
the connected device is too high, sound distortion
may occur. Should this happen, lower the volume
of the connected device. If volume level is too low,
increase the volume of the connected device.
Note:
To prevent noise interference, place the unit away from the
television.
Headphones
■
Do not turn the volume on to full at switch on and listen
●
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
Before plugging in or unplugging the headphone,
●
reduce the volume.
Be sure your headphone has a 3.5 mm (1/8") diameter
●
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
Plugging in the headphone disconnects the speakers
●
automatically. Adjust the volume using the VOLUME
control.
Audio cable
(not supplied)
E-1

Troubleshooting chart

Many potential problems can be resolved by the owner
without calling a service technician. If something is wrong
with this product, check the following before calling your
authorized SHARP dealer or service center.
General
■
Symptom
The clock is not
●
set to the correct
time.
When a button is
●
pressed, the unit
does not respond.
No sound is heard.
●
CD player
■
Symptom
Playback does
●
not start.
Playback stops
●
in the middle or
is not performed
properly.
Playback sounds
●
are skipped, or
stopped in the
middle of a track.
Remote control
■
Symptom
The remote control
●
does not operate.
Tuner
■
Symptom
The radio makes
●
unusual noises
continuously.
Possible cause
Did a power failure occur?
●
Reset the clock. (Refer page
11)
Set the unit to the power
●
stand-by mode and then turn
it back on.
If the unit still malfunctions,
●
reset it. (Refer page 14)
Is the volume level set to
●
"MIN"?
Are the headphones connected?
●
Are the speaker wires discon-
●
nected?
Possible cause
Is the disc loaded upside
●
down?
Does the disc satisfy the
●
standards?
Is the disc distorted or
●
scratched?
Is the unit located near
●
excessive vibrations?
Is the disc very dirty?
●
Has condensation formed
●
inside the unit?
Possible cause
Is the AC power lead of the
●
unit plugged in?
Is the battery
●
correct?
Is the battery dead?
●
Is the distance or angle
●
incorrect?
Does the remote control
●
sensor receive strong light?
Possible cause
Is the unit placed near the TV
●
or computer?
Is the FM aerial placed
●
properly?
Move the aerial away from
the AC power lead if it is
located nearby.
polarity