Adamson M Series User Manual page 17

Config - Device Configuration
SYSTEM-SETUP MENU:Config
MODE:2-Way
• MODE - configures the mode of operation.
Mode: Out 
None Any
Stereo 2-Way In
Stereo -Way In
Stereo 4-Way In
The unit assigns the Input source for the corresponding outputs when the Mode of Configuration is selected. The
crossover point parameters like the filter type, cut-off frequency and slope have to be configured manually in
the Xover Menu in each Output menu.
*Note: The configuration mode configures the input sources when selected. The user can change the source
afterwards if desired. It does not keep the configuration in memory.
Copy - Copy channels
SYSTEM-SETUP MENU:Copy
SOURCE:In1
TARGET:In2
Copy Channels from the source to the target. When the Source and Targets are both Inputs or Outputs, all audio
parameters will be copied. When one of the Source or the Target is an input while the other is an output, only the
Level, Polarity, Delay and EQ are copied.
• SOURCE - Channel to be copied from.
• TARGET - Channel to be copied to.
6. System Menus
Out 2 Out 
Any Any
In In2
In In
In In
Out 4 Out 5
Any Any
In2 Any
In2 In2
In In2
M Series Processor User Manual - Page 7 of 26
Out 6 Out 7
Any Any
Any Any
In2 Any
In2 In2
Out 8
Any
Any
Any
In2