System Menus - Adamson M Series User Manual

The System Menus allow the user to control and change parameters that are related to the system behavior
and general operation. It can be accessed by pressing the Sys key in the main menu (when no Input/Output or
System Menu is activated). All System Menus require the Enter key to be pressed for the selected action.
Recall - Program Recall
The M Series Processor has a built in non-volatile memory that can store up to 0 different program setups. A
program can be recalled using this menu.
SYSTEM-SETUP MENU:Store
PROG:01
NAME:XXXXXXXXXXXX
• PROG - Program Number to be recalled..
• NAME - Program Name of the program. This is read only, the user has no access to them.
Store - Program store
The M Series Processor has a built in non-volatile memory that can store up to 0 different program setups. A
program can be stored using this menu. The old program with the same program number will be replaced.
Once the program is stored in the flash memory, it can be recalled at a later time, even after power down.
SYSTEM-SETUP MENU:Recall
PROG:01
NAME:XXXXXXXXXXXX
• PROG - Program Number for the current data to be stored.
• NAME - Program Name, allows a maximum length of 2 characters.

6. System Menus

M Series Processor User Manual - Page 6 of 26