Advertisement
Available languages
Available languages
Junction
Box
Location
Locate junction
box as shown
in Figure 7.
If a service cord is used, the wall receptacle should be
located in accordance with the dimensions below.
Center
Line of
Range
Locate Electrical Hook-up
Inside Shaded Area
ALL
"--.
Center
" Line of
Range
Figure 7
ement
To eliminate the risk of burns or fire by
reaching over heated surface units, cabinet storage space
located above the range should be avoided. If cabinet
storage space is to be provided, the risk can be reduced
by installing a range hood that projects horizontally a
minimum of 5" (12.7 cm) beyond the bottom of the
cabinet.
on the floor where the back edge of the range will be.
Now install anti-tip brackets (see "Anti-Tip Brackets
Installation"
page 8).
If range will not be installed
against a cabinet,
move
range into final position. Mark on the floor along both
sides of the range. If back of range will
not be flush
with the wall (the location of the outlet may not allow
the range to be positioned against the wall), draw a
line on the floor where the back edge of the range will
be. Now install anti-tip brackets (see "Anti-Tip Brackets
Installation",
page 8).
Range
Installation
NOTE:
1.
The back of the range may be installed directly
against the rear wall of the structure.
2.
These ranges conform to U.L. requirements for "0"
spacing from the range to adjacent vertical walls
above the countertop
level. However, to reduce
possible scorching of vertical walls and to minimize
potential fire hazards under abnormal surface unit
use conditions such as high heat or no pans, a
minimum of 2" (5.1 cm) spacing should be provided
on both sides of the cooktop.
3.
If a wall is present on the left side of range, allow
a minimum of 2 3/4" (7 cm) to open the auxiliary
door.
©
Center
Line of
Range
I
Follow instructions
for
the type of installation
you have
Figure 8
If range will be installed
with
a cabinet on both
sides, draw a center line on the floor between the
cabinets (see figure 8). If back of range will not be
flush with the wall (the location of the outlet may not
allow the range to be positioned against the wall), draw
a line on the floor where the back edge of the range will
be. Now install anti-tip brackets (see "Anti-Tip Bracket
Installation, page 8).
If range will be installed
with
a cabinet on one side
only, move the range into final position. Draw a line on
the floor along the side of the range that is not against
the cabinet. If back of range will not be flush with
the wall (the location of the outlet may not allow the
range to be positioned against the wall), draw a line
Excessive
Weight
Hazard
• Use 2 or more
people
to move
and
install
range.
• Failure
to follow
this instruction
can result
in
back or other
injury.
Preparation
1.
Put on safety glasses and gloves. Remove oven racks
and parts package from inside the oven. Remove
shipping materials, tape and protective film from the
range.
2.
Take 4 cardboard corners from the carton. Stack
one on top of another. Repeat with other 2 corners.
Place corners lengthwise on the floor in back of the
range to support range.
3.
Firmly grasp the range and gently lay it on its back
on the cardboard corners.
4.
Remove the 4 shipping bolts from the skid. Discard
skid.
5.
Lay a large piece of cardboard in front of the range.
Carefully stand the range upright on cardboard.
6.
Adjust the leveling legs to a point where the range
base does not touch the floor.
6
Advertisement
