Frigidaire FASG7074NR2 Installation Manual page 16

Water connectionr continued (Steam Model only)
If your installation has room for the COLD water
supply to accept the "Y" connector directly, thread
the "Y" connector to the COLD water supply and
snug it by hand; then tighten it another 2/3 turn
with pliers,
If you were able to install the "Y" connector directly to
the COLD water supply, please skip to step 8.
6 If there is not room to install the "Y" connector
directly, thread a short extension hose on to the
COLD water supply and snug it by hand; then
tighten it another 2/3 turn with pliers.
Short extension available from your local hardware
supplier. Extension hose must meet qualifications for
7 Thread the "Y" connector to the short extension
hose and snug it by hand; then tighten it another
2/3 turn with pliers.
8 Connect the COLD inlet hose for the washer to the
"Y" connector and snug it by hand; then tighten it
another 2/3 turn with pliers.
9 Connect the straight end of the long hose from the
kit to the other outlet on the "Y" connector and
snug it by hand. Connect the hose's 90 ° coupling to
the brass water inlet on the back of the dryer and
snug it by hand. Tighten each connection of the
dryer inlet hose another 2/3 turn with pliers.
10 Turn on the water and check for leaks at all
connections.
DIRECT CONNECTION
:_ OR WITH EXTENSION*
_____ WATER INLET
ON DRYER
COLD WATER SUPPLY
HOSE TO WASHER
*Laundry hose extension not included with dryer.