General Installation - Frigidaire FASG7074NR2 Installation Manual

Hide thumbs

Advertisement

Table of Contents
General
installation
1
Connect the exhaust duct to the outside exhaust
system. Use of a 4" (102 mm) clamp (item A) is
recommended to connect the dryer to the exhaust vent
system. Use metal foil tape to seal all other joints.
2
Use a carpenter's level to level your dryer front-to-back
and side-to-side.
3
Use adjustable pliers to adjust the leveling legs so the
dryer is level front-to-rear
and side-to-side, and stable
corner-to-comer.
4
Press down on alternate corners and sides and feel for
the slightest movement. Adjust the appropriate
leg(s)
so the dryer sits solidly on the floor on ALL four legs.
Keep the leveling leg extension at a minimum for best
performance of the dryer.
Be sure the power is off at a circuit breaker/fuse box before
plugging the power cord into an outlet,
5
Plug the power cord into a grounded outlet.
6
Turn on the power at the circuit breaker/fuse box.
7
Read the Use & Care Guide provided with the dryer. It
contains valuable and helpful information that will save
you time and money.
8
If you have any questions during initial operation,
please review the "Avoid Service Checklist" in your Use
& Care Guide before calling for service.
9
Place these instructions in a location near the dryer for
future reference.
A wiring diagram and technical data sheet are located

Advertisement

Table of Contents
loading

  Related Manuals for Frigidaire FASG7074NR2