Aligning The Wall Plate - GE PVM1790 Installation Instructions Manual

Installation Instructions
ALIGNING THE WALL PLATE
Hole
Drawa Vertical
Lineon Wall
r,_e-- from Centerof
TopCabinet
HoleC
-- CAUTION:
Wear gloves to avoid cutting
fingers on sharp edges.
ol
0
AreaE 0
I
I
I
HoleD
[]i_] Drow o verticol line on the woll ot the center of the 30"
wide spoce.
I_] Use the mounting plote as the template for the reor woe
Plocethe mounting plote on the woll, moking sure thot
the tobs ore touching the bottom of the cabinet or
the level line drawn in Step C for cabinets with front
overhang. Line up the notch and center line on
the mounting plate to the center line on the wall.
_] While holding the mounting plote with one hGnd,drow
circles on the woll ot holes A, B, C ond D (seeillustrotion
obove/octuol plote morked with orrows). Four holes
must be used for mounting.
NOTE: Holes C ond D ore inside oreo E.If neither C nor D
is in o stud, find o stud somewhere in oreo E ond drow o
fifth circle to line up with the stud. It is importont to use
at least one wood screw mounted firmly in a stud
to support the weight of the oven.
Set the mounting plate aside.
A
WARNI NG:
Risk of electric shock. Can
cause injury or death. Take care to not drill into electrical
wiring inside wells or cabinets.
[_ Drill holes on the circles. If there is o stud, drill o 3/1_" h ole
for wood screws. For holes thot don't line up with o stud,
drill o YJ' hole for toggle bolts.
NOTE:DO NOT MOUNTTHE PLATEATTHISTIME.
10