GE PVM1790 Installation Instructions Manual page 17

Installation Instructions
I_ Roll the blower unit 90 ° so that fan blade openings
are facing out the back of the oven.
Before Rollim
Back of
Oven
After Rolling
Backof
Oven
I_ Locate the two "knockout" plates, on the rear oven
panel, near the top of the oven.
Using tin snips, carefully cut the web area from the
two holes side-by-side (that secure the knockouts to
the oven). Cut all four webs on both rear knockouts;
this will allow the ventilation fan airflow to exhaust
out the rear of the oven.
CAUTION:
Be sure to trim the sharp
edges from theopeningsafter removingthe
knockoutplates.
Oven Rear Panel
__ Snipall 4 webs
on eachknockout
__ panelandremove
____ the metal knockouts
__i _'_ for rearairflow.
[_ Place the blower unit back into the opening.
A
It,CAUTION:
Do not puI' or stretch
the blower unit wiring. Hake sure the wires
are not pinched.
NOTE:The blower unit exhaust openings should
match exhaust openings on rear of oven.
%
Replace the blower plate in the same position
as before with the screws.
J Blower P lateScrews
I _ _ Blower P late
I
Oven
I_ Insert the tabs on each side of the damper
into the holes at the inside rear of the adaptor.
I
Exhaust
Adaptor
I_ Attach the exhaust adaptor to the rear of the oven
by sliding it into the guides at the top center of the
back of the oven.
Exhaust A da
Slide exhaust
adaptorinto
guideson
ovenrear.
Backof Oven
Locking
Tabs Guides
Push in securely until it is in the lower locking tabs.
Take care to assure the damper hinge is installed
so that it is at the top and that the damper swings
freely.
[_ Secure the exhaust adaptor to the oven with
the two bronze metal screws provided.
17