Recirculation; Mount The Oven - GE JVM1665 Installation Instructions Manual

Installation Instructions
ADAPTING BLOWER FOR
RECIRCULATION {continued)
[_ Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Hake sure the wires are not pinched.
[_ Replace blower plate and replace screws for blower
plate and blower motor removed in Step 1.
BlowerPlate Screws
__,_ Blower P late
Back of Oven
F---- BlowerMotor Screw
| MOUNT THE OVEN
FOREASIERINSTALLATION AND PERSONAL SAFETY, W E
RECOMMEND THATTWO PEOPLEINSTALLTHIS OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from over
tightening screws.
NOTE: When mounting
the oven, thread power
cord through hole in
bottom of top cabinet.
Keep it tight throughout
Steps 1-]. Do not pinch
cord or lift oven bu pulling
cord. _____.
[] Lift oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
tabs of mounting plate.
\
[_ Rotate front of oven
up against cabinet
bottom.
CabinetFront
CabinetBottomShelf
Block
-_oEquivalent to Depth
f CabinetRecess
Self-AligningScrew
OvenTop
21