Blower Fl)R; Recirculation - GE SCB1000 Installation Instructions Manual

Installation Instructions
[-C--_ADAPTING BLOWER FOR
RECIRCULATION
NOTE: Tile exhaust adaptor with damper is not needed
tor recirculating models. Y_m mm want to sa_e them tor
possible fllture use.
_ Remoxe and saxe screws that hold tile blower plate
to tile oxen.
,_<[-_ Blower Plate Screws
Retaining
Flange _' i
_' \ I I BlowerPlate
___j I[ je IBack OfOven
_-] Slide tile blower plate fl'om trader its retaining flange
and 1N it off. Remme and saxe screw that holds tile
blower
ii/otoi" to o_en.
RetainingFlange __BIo!er
_7 _._ BlowerMotor
Screw
[_ Careflfll) pull out tile blower trait. Tile wires will
extend fin" enough to allow )ou to a(!iust tile
blower trait.
_Roll tile blower trait 90 ° so that tim blade openings
are lacing toward tile fl'ont of tile oxen.
BEFORE: Fan Blade
Openings Facing_
R011 4_
AFTER: Fan Blade
Openings Facing _"----.-...._
Forward
NOTE: Make sure wires remain routed in tile grooxes of
the Illotor fKlI/le,
_] Place tile blower trait back into tile oi)ening,.
CAUTION: Do not i ,/,ll stretch tile blower
trait wiring. Make sure tile wires are not pinched.
2O