Recirculating; Preparation Of Top Cabinet - GE JVM1665 Installation Instructions Manual

Installation Instructions
RECIRCULATING
(Non-Vented Ductless}
L
t
r
E
ATTACH THE MOUNTING PLATE
TO TH E WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
[] Remove the toggle wings from the bolts.
[_ Insert the bolts into the mounting plate through
the holes designated to go into druwall and
reattach the toggle wings to s/4"onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
-_l_-_i_----Th icl<n ess
Mounting
Plate
O
Bolt End
[_ Place the mounting plate against the wall
and insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
CAUTION: Be careful to avoid pinching fingers between
the back of the mounting plate and the wall.
[_ Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
IC2.1 USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOPCABINETTEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINETtemplate.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
19