Adapting Blower For Outside Back Exhaust - GE JVM1665 Installation Instructions Manual

Installation Instructions
| ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
[] Remove the two screws that hold the blower plate
and remove the screw holding the blower motor to
the oven. Slide blower plate from under its retaining
flange.
Retaining ? "
Flange "__0"_ Blower P late
[_ Carefully pull out the blower unit. The wires
will extend far enough to allow Uou to adjust
the blower unit.
Bad<
of Oven
[_ Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Oven
AfterRotation
Back of
Oven
[_ Roll the blower unit 90 ° so that fan blade
openings are facing out the back of the oven.
Before Rollin(
--__ After RollingA
Oven
Back of
Oven
[] Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Hake sure the wires are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of oven.
[_ Replace the blower plate in the same position
as before and replace the screws for the blower
plate and blower motor.
BlowerPlateScrews
_----_---_ _ Blower Plate
_ Backof Oven
,,_--__'_-_ BlowerMotor Screw
17