Preparation Of Top Cabinet; Checking For Proper Damper Operation; Mount The Oven; Adaptor - GE JVM1490 Installation Instructions Manual

Installation instructions
[-_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a
CUtOUt
large enough for tile exhaust adaptor.
• Read the instructions on tile TOP CABINET
TEMPI ATE.
• Tape it underneath the top cabinet.
• Drill the holes, tbllowing the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling boles
in the cabinet bottom.
ASSEMBLE AND
iNSTALL ADAPTOR
Damper
-- Exhaust
Adaptor
_,_2_ BlowerPlate
-I
[]Place tile oven in its upright position, with the top
of the unit fi_cing up.
[]Insert tile tabs on each side of the damper into tile
boles at tile inside rear of tile adaptor.
_ Attach the exhaust adaptor to the blower plate with
tile two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adj usunents to assure proper
alignment with your house exhaust duct af_er the
oven is installed.
MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around tlle power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet f?ont bangs below tile cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting tile
oven, thread power cord
through hole in bottom
of top cabinet. Keep it fight
throughout Steps 1-3.
Do not pinch cord or lift
oven by pulling cord.
_Lift tilt it
oven,
forward, and hook
slots at back bottom
edge onto two lower
robs of mounting
plate.
[] Rotate flont of
oven
up against cabinet
bottom.
_Insert a self:aligning screw through top center
cabinet hole. Temporarily secure tlle oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord tight.
Be careful not to pinch the cord, especially when
mounting flush to bottom of cabinet.
13