GE JDP47 Installation Instructions Manual page 11

Installation Instructions
[-61 Standard Installation Instructions on,.
e trim
Attach the Lower Trim
Attach the lower trim (supplied separately
with the range) to the bottom of the
vertical side trim with the/4 screws
supplied.
trim
Att(]ct 2
screws
Lower
right end
of front
frame
Locating the Stop Screw
It is suggested that two people lift the
range and carefully slide it towards the
back of the opening. When the range
is approximately 1" from the back of
the opening, lift the front of the range
approximatley 1/2" to clear the stop screw
located in the sides of the cabinet. Slide
the range until the range is seated into the
opening.
Lower the front of the range onto the
countertop.
Check For Proper Installation of
the Stop Screw
Look at both sides of the range under the
door. The stop screws must be located in
the notch on the sides of the range, and
not touch the top of the notch when the
range is fully seated on the countertop. If
the screws do not meet the requirements,
move the screws to a position that meets
these requirements.
(See illustration below.)
Lower
trim
Shoulder screw
/ oo]
I eliot /
Notch in bottom
of side trim
11 (Continued on following page)