GE JDP47 Installation Instructions Manual page 10

Installation Instructions
ID]Standard Installation Instructions con,.
Install Stop Screw
These screws prevent the range from
sliding out of position during operation.
I I II _L'_,t _.:. to ''''_''''''_--
_1 t_',_io.__%_
o'"_ 1/ II °_
IH'--_
e°o. ,Oe
Carefully mark the cabinet for the
location of the stop screws. Drill 1/8"
pilot holes into the cabinet, each side of
the range. (Make sure not to drill entirely
through the cabinet wall.) Carefully turn
the shoulder screws into the pilot holes
until they ore tight.
Placing the Range into the
Opening
It is suggested that two people lift the
range into place, carefully setting the
side metal flanges under the glass on
the edges of the countertop opening.
The protective channels must be in
place (if supplied)during this operation.
Lift and Slide Range
on Countertop
Range
Cabinet
Placing the Range into the
Opening (Continued)
Carefully slide the range toward the back of the
opening. Stop pushing the Range when there
is still o 4" gap at the front before flushing the
Range with the countertop.
Countertop
Gap Approx. 4"
Gop Approx. 4"
Remove the Protective Channels
I-_ (if provided)
Carefully remove the protective channels
from the sides of the glass cooktop. This
may require a slight lifting of the range to
remove the weight of the range from the
protective channels.
Glass Cooktop Protective Cover
Remove Protective Cover From
Both Sides After Range Is In Cabinet
10
(Continued on following poge)