How To Wire Your Ceiling Fan; Installing The Canopy Housing - Fanimation The Edgewood TF610 Series Owner's Manual

Decorative deluxe ceiling fan

Hide thumbs Also See for The Edgewood TF610 Series:

Owner's manual (28 pages)

Table of Contents

Available languages

To avoid possible ﬁre or shock, be sure electricity is

turned off at the main fuse box before hanging.

(Figure 11)

1. Connect the green grounding lead from the hanger

ball and the green grounding lead from the hanger

bracket to the supply grounding conductor (this may

be a bare wire or wire with green colored insulation).

Securely connect wires with wire connectors supplied.

(Figure 12)

2. Securely connect the white fan motor wire to the

white supply (neutral) wire using wire connector

supplied. Securely connect the black fan motor wire

and blue wire to the black supply wire using wire

connector supplied. (Figure 12)

3. After splicing and making the wire connections, the

wires should be spread apart and turned upward with

the grounded conductor and the equipment-grounding

conductor on one side of the outlet box and the

ungrounded conductor on the other side of the outlet

box. (Figure 13)

Check to see that all connections are tight, including

ground, and that no bare wire is visible at the wire

connectors, except for the ground wire. Do not operate

fan until the blades are in place. Noise and fan damage

could result.

NOTE: This step is applicable after the necessary wiring

is completed.

▲WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy housing

and not pinched between the housing and the ceiling.

1. Remove one of the two shoulder screws in the

hanger bracket. Loosen the second shoulder screw

without fully removing it. Assemble canopy by

rotating key slot in canopy over shoulder screw in

hanger bracket. Tighten shoulder screw. Fully

assemble and tighten second shoulder screw that

was previously removed. (Figure 14a)

Securely attach and tighten the canopy screw cover

over the shoulder screws in the hanger bracket utilizing

the keyslot twist-lock feature. (Figrue 14b)