GE Monogram ZIK30GNZAII Design & Installation Manual page 13

Installation instructions
STEP 1 REMOVE PACKAGING
CAUTION:
THE REFRIGERATOR IS
TOP-HEAVY. BE CAREFUL WHEN MOVING.
, Cut bands and tape on the top and bottom
of packaging with a utility knife.
, Unfold the cardboard seams and remove the top
of the packaging.
Slide the remainder of the box off of the appliance.
You can use a box cutter to cut the remaining
cardboard being VERYCAREFULnot to scratch
the appliance.
Remove the Styrofoam supports from around the unit.
. DO NOT remove door band or lower EPSbanded
part until unit is ready to go into enclosure.
, Cut EPSskid at the sides near the front from the back
of the unit.
, Push unit forward & remove rear portion of the EPS
skid.
, Carefully lower rear onto the floor.
, Lean unit back slightly & remove front portion of the
EPSskid.
, Discard all unused packaging materials appropriately.
, The unit can now be moved using an appliance hand
truck or rolled on a properly protected floor by 2
people.
, Leave any protective film on the refrigerator until
installation is complete.
13