GE Monogram ZV850 Installation Instructions Manual page 13

Installation
36" Island Vent Hood
Install
Hood
Align Duct
Connector t o ..
HouseDuct
/ Align
Mounting
Studs
Bottom I
gU?tr j
StopScrew __ o / Install
--l /4,ock
H II[ot _ --1 J
washer
• _ 4 Nuts
Note: TWO PEOPLE ARE REQUIRED TO
COMPLETE THIS INSTALLATION!
• I,ifl the hood up to the support frame.
Carefldly align tim hood mounting studs
into the support flame holes, and at tim
same time, guide tim hood duct connector
into tim house duct.
• Install 4 nuts and lock washers to the
mounting studs. Tighten with a 10mm
wrencll.
• Check hood level in both directions.
• Check to be sure that the duct is positioned
over tim hood connectoL
• Seal tim duct connection with duct rope.
Note: Do not drive screws through lower duct
connection. Doing so will prevent proper
damper operation.
10
Connect
Electrical
Verify that power is turned off at the source.
If house wiring is not 2-wire with
a ground wire, a ground must be
provided by the insmlleL
When house wiring is aluminum,
be sure to use U.I,. approved
anti-oxidant compound and
aluminum-to-copper connectors.
• Install strain relief into tim knockout of tim
junction box coveL
• Insert house wiring through strain relief and
tighten.
• Connect white leads to branch circuit white
lead.
• Connect black leads to branch circuit black
lead.
• Connect green/yellow leads to branch
circuit green or bare ground lead.
• Secure all connections with wire ntlts Oil
each elecuical connectoL
• Push wires into junction box and replace
coveL Be sure wires are not pinched.
13