GE JGP328 Installation Instructions Manual page 14

Installation Instructions
MAKING THE LP CONVERSION (CONT.)
E1
CHANGE COOKTOP BURNER
ORIFICES
Remove the top grotes,
burner cops, ond burner
heods.
Remove the spork
igniters from the burner
bose (if required to
occess the orifices).
Using o No. 15 "Torx"
heod driver bit, remove
the screws holding the
burner bose in position.
_[ Remove This
_ Assembly
-. :_o<. J
Orifice Spud Locoted
Through This Opening
Using o 7mm nut driver,
remove the top burner
orifices. These moy be
occessed through the
hole in the cooktop.
Burner cop
_ Burner
Spork igniter bose
18,000 BTU Burner
Ion some models)
Burner
cop
_Burner
Burner
_ heod
bose
Spork igniter
CHANGE COOKTOP BURNER
ORIFICES (CONT.)
NOTE: On most burners,
the orifices hove o spring- Retoiner
Iooded retoining ring Ground Ring
the hex heud to hold the
orifice in the nut driver during
instullution ond removol. A
slight omount of force is required to push the nut
driver down over the ring.
14