Drain Line Installation - GE GHDA690P02BB Installation Instructions Manual

Installation Instructions
CONNECT DP_,,IN LINE
FOLLOW ALL LOCAL CODES AND C._DINANCES.
The drain hose moldedend willfit 5/8",3/4"or 1"
diameterconnectionson the air gap,wastetee or
disposer.Outon the markedlineas requiredfor your
installation.
Cutting Lines
Figure 20
IMPORTANT:Do not cut corrugated
portion of hose
• Ifa longerdrain hoseis required,add up to 42" off
lengthfor atotal of 10ft. to the factory installedhose.
Use5/8"or 7/8"inside diameter hoseand a couplerto
connect the two hoseends.Securethe connection
with hoseclamps.
,, HoseClamp
/ Coupler
Hose Clamp Figure 21
eSecure the drain hoseto the air gap,waste tee or
disposerwith clamps.
NOTE: T OTAL DRAINHOSE LENGTH MUST NOTEXOEED
10 FEET FORPROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Oonnectdrain lineto air gap,waste tee or disposer
using either previouslydetermined method.
M÷thod 1 -Air gap with waste tee or disposer
.,..,"J_ eJ ...... _ A
Wade TeeInstallation Disposer Installal]on
Figure 22
Methcd 2- High drain loop with waste fee or disposer
Fasten tounderside Fasten to underside
_ i._ of c0U nterl0 D"
/
!
Waste Tp.eInstallal]on Disposer Installal]on
Figure 23
Remove
IMPORTANT --
hopper
When connecting drain line to plug
disposer,check to be sure that drain
plug has been removed.DISH-
WASHER WILL NOTDRAINIF PLUG IS LEFTIN PLAOE.
TIP:Avoid unnecessaryservice call charges. Always
be suredisposer drain plug has been removedbefore
attaching dishwasherdrain hoseto the disposer.
10