Furnacemaintenance - ICP 8MPT Installation Insrtuctions

Continuous- Fan using "G"
Energizing the "G" terminal on the furnace control board provides
continuous fan operation. This is done by connecting the G
terminal of the thermostat to the G terminal on the furnace control
board. When the FAN switch is turned from auto to ON the fan wilt
operate continuously at airflow selected by DIP SW2 switch #1
and DIP SW2 switch #2. EAC will be energized in this mode.
NOTE: In heating, the fan will not turn off during furnace ignition
and warm up.
Hard Wired Continuous Fan Operation
Not available for variable speed models.
Variable Speed (*8MPV) Tap Select Interface Board (TSIB)
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
• 0 0 0 •
iiiiAC?i_:l Jo E_=
BRN C - YE [_1
_, I ............ I_1 l [] ............... _;
_oi_v n nnnn nn n_/_°_c°::°:z'°_ _
........ O '___
___
ON = 1
!r Ir
OFF = 0
CONTINUOUS
CFM SELECT
I II _E_T'"_s_ II C°°L"° CF_ IICOO'"_O_'OFF
SELECT SELECT DELAY PROFILES
HP MODE SELECTION /
HEAT PUMP EFFICIENCY OR
I
HP COMFORT SELECT ON I
I
I
25 25 54
13. Furnace Maintenance
FIRE, EXPLOSION, OR CARBON MONOXIDE
POISONING HAZARD
Failure to have the furnace inspected and
maintained could result in personal injury, death,
and/or property damage.
It is recommended that the furnace be inspected
and serviced on an annual basis (before the
heating season) by a qualified service agency.
See "User's Information Manual".
ELECTRICAL SHOCK, FIRE OR EXPLOSION
HAZARD
Failure to follow this warning could result in
personal injury, death, and/or property damage.
• Before servicing, disconnect all electrical power
to furnace.
• When servicing controls, label all wires prior to
disconnecting. Reconnect wires correctly.
• Verify proper operation after servicing.
33
Specifications are subject to change without notice
441 01 202301