Hoover 41 Installation Instructions Manual page 12

Wiring Instructions for Electrified Central Vacuum Inlet Valve Continued..
7. Connect Low Voltage Wires (3) under Contact
Screws (4) of Inlet Valve Face Plate.
8. Push inlet Valve Face Plate (7) to Mounting
Plate (8). At same time push Building Wire
Conductors (1) and connectors (6) into Wiring
Compartment (9).
9. Secure inlet Value Face Plate (7) to Mounting
Plate (8) using the 2 supplied color matched
Screws (10).
Finished Construction
After pipe, Low Voltage Wire (3) Electrical Building
Wire (1) (A.C. Power) are in place and opening in
wall has been carefully exactly cut (page 8):
1. Remove mounting plate nailing flange (11) (see
page 8).
2. Glue 90 ° Ell over projecting socket on the back
of Mounting Plate (8) (as on page 8.) (Position with
wiring compartment on top.)
4. install Building Wire Conductors (1) (A.C. Power)
through the approved type electrical box connector
(2) until they protrude approximately 6" through
connector into the Wiring Compartment (9).
5. Loosen the screws (12) that hold the bottom
Cover Plate (14) (marked "DO NOT REMOVE") so
that slotted tabs of finished Wall Clip (15) can be
places behind the screw heads.
6. Position the modified Mounting Plate with the
short Ell glued on and the Low Voltage and
Building Wired (3) and (1) protruding through it,
into the wall opening, and then glue it to the tubing
(as on page 8).
7. Slip tabs of Finished Wall Clip (15) behind screw
heads (12) and then tighten screws.
Note: this Clip will retain Mounting Plate in wall and
allow for easier electrical connections.
8. Follow steps 6-9 from new construction.
3. Push Low Voltage Wires (3) through hole in
lower Cover Plate (14) from back side.
To obtain approved Hoover _ service and genuine Hoover _ parts, locate the nearest Authorized Hoover _
Warranty Service Dealer (Depot) by:
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household".
• Visit our website at hoover.com. Follow the service center link to find the service outlet nearest you.
• For a referral of authorized service outlet locations call 1-800-944-9200.
Do not send your vacuum to Hoover _, Inc., Company in Glenwillow for service. This will only result in delay.
if you need further assistance:
To speak with a customer service representative call 1-800-944-9200; Mon-Fri 8am-7pm EST.
Always identify your vacuum by the complete model number when requesting information or ordering parts.
(The model number appears on the side of the Power Canister.)
Please do not return this product to the store.
12