Installation Procedure; Prepare The Countertop; Seal The Cooktop With Foam Tape - Bosch NGM Installation Manual

Countertop Requirements
30" Models
313/16''
(97)
13"
(332)
gas
(788)_______ connection
191/8''
13 17/8,,
(332) (48)
measurement in inches/mm
36" Models
min.30"
(762) 211/4"
313/16"1
(97)
13"
(332)
15/167,
--I - t-
37" _(15)
gas
(940) _. connection
191/8 ''
(486) maxo3"
(76)
13 17/8,,
(332) (48)
measurement in inches/mm
Mounting Requirements
Use the mounting brackets supplied. See "Install the
Cooktop" on page 5 for further details.
Ventilation Recommendations
We strongly recommend the installation of a ventilation
hood above this appliance. The hood must be installed
according to instructions furnished with the hood.
Installation Procedure
,_ WARNING:
To avoid electrical shock hazard, before
installing the cooktop, switch power off at the
service panel to prevent the power from being
switched on accidentally.
Prepare the Countertop
Cut out the countertop per the dimensions shown in
"Cabinet Requirements" on page 3.
Some solid surface materials, such as Surell
TM
and
Corian®, require different cutting methods. Consult with the
Figure 2: Cutout Dimensions
solid surface manufacturer for the correct cutting method
needed. Apply heat reflective tape such as Scotch
Aluminum Foil Tape #425 or #427 (not included) around
the cutout so that it folds over on the top and sides. Do not
wrap the tape underneath the cooktop. Be sure the tape
extends beyond the outermost flange of the cooktop. All
corners should be covered with tape.
• Heat ReflectiveTa e
Section "A - A"
Figure 3: Counter Cutout - Solid Surface Countertops
Seal the Cooktop with Foam Tape
Apply the self adhesive foam tape in one continuous
rectangle directly to the counter around the perimeter of the
cutout as shown by the dotted line in Figure 4: "Counter
English 4