Table of Contents
Advertisement
Available languages
Available languages
Installation Procedure
Prepare Installation Space
Create the cut-out in the countertop according to the
installation drawings. The angle of the cut surface to the
countertop must be 90°.
After creating the cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to your
countertop.
WARNING
9
To avoid electrical shock hazard, before installing
the cooktop, switch power off at the service panel to
prevent the power from being switched on
accidentally.
Cut out the countertop per the dimensions shown in the
section "Countertop Requirements".
If there is no oven beneath the cooktop, install a non-
combustible floor with a
floor and the bottom of the cooktop.
The distance from the intermediate floor to the power
supply connection for the appliance must be at least
(10 mm).
Install the Cooktop
WARNING
9
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
CAUTION
9
Sharp edges. Use protective gloves when installing
the cooktop.
8
I n s t a l l a t i o n P r o c e d u r e
P r e p a r e I n s t a l l a t i o n S p a c e
/
" (10 mm) space between the
3
8
Apply the included foam tape to the underside of the
1.
cooktop.
Screw each one of the clips into the position shown in
2.
the following image, so that they are free to rotate.
/
"
3
8
Advertisement
Chapters
Table of Contents
