•
Remove alltapeandpackaging b efore using theappliance. Destroy thepack-
agingafterunpacking t heappliance. Never a llowchildren toplaywithpackag-
ingmaterial.
•
Nevermodify or altertheconstruction o ftheappliance. Forexample, donot
remove leveling legs,panels, wirecoversoranti-tip brackets/screws.
•
Toeliminate theriskofburnsorfireby reaching o verheated surface units,
cabinet s torage space located above thesurface unitsshouldbeavoided. I f
cabinet storage isto beprovided, theriskcanbereduced byinstalling a hood
thatprojects horizontally a minimum of5 inches beyond thebottom of the
cabinet.
•
Verify thatcabinets above thecooktop area maximum of 13"(330mm)deep.
Installation
Before You Begin
Tools and Parts Needed
Additional Parts Needed For
Hard Wire Installations
Parts Included
40 or 50 Amp Power Supply Cord Kit (depending on local code)
Note: Not necessary for Canadian installations
Measuring Tape
Phillips Head Screwdriver
1-1/4" (31.8 mm) Wrench
Pencil
T-20 Torx Screwdriver
Screws (2) and Anchors (2) for Anti-Tip Bracket (Style will vary depending on
mounting surface)
Level
Drill and Drill Bit
Soapy Water
Safety Gloves and Goggles
Tape (Optional)
Cloth or Cardboard (Optional - to Protect Floor)
•
Flexible Conduit
•
Torque Wrench
•
Note: Power Supply Cord Kit Not Necessary For Hard Wire Installations
•
Anti-Tip Bracket
•
Foam Tape
•
Terminal Lugs (For Use With Hard Wire Installations) (not necessary for
Canadian installations)
English 2