Advertisement
Check Back of Range for Proper
Installation
Adjust Front of Range for Proper
Installation
Test the Installation
3.
Slide range into opening, being careful not to damage countertops, floors, or
the range drawer front. Do not apply pressure to cooktop when sliding into
position.
Tip: Remove the drawer to prevent damage.
.
2.
When properly installed, the cooktop trim around the back of the range will
rest lightly on the countertop.
There should not be any gap between the countertop and the trim; however,
the weight of the range must not rest on the countertop. Look under the range
to verify that both back legs are resting solidly on the floor. Also verify that the
left range leg is under the anti-tip bracket.
Caution:
Verify that the weight of the range is not resting on the counterrop.
This
could result in damage to the countertop and the appliance.
3.
If the back legs are not resting solidly on the floor or the left leg is not under
the anti-tip bracket, slide range out, adjust legs and slide back in.
1. Adjust front leveling legs so that the cooktop trim rests snugly against the
countertop all the way around.
2.
Verify that both front legs are resting solidly on the floor.
3.
Use a level to verify that the range is level and plumb.
Turn on Power at Breaker
Caution:
If the display flashes and beeps, the polarity of the wiring may be
reversed. Reversed polarity can damage the range and can result in electrical
shock hazard. Immediately switch off power at the breaker and return to "Connect
Electric - Range Cord" on page 8.
Service
Before Calling
Service
See Use and Care Manual for troubleshooting
information. Refer to the Warranty
in the Use and Care Manual.
To reach a service representative, see the contact information at the front of the
manual. Please be prepared with the information printed on your product data
plate when calling.
English 16
Advertisement
