Advertisement
3.
Use a 1%e"combination
wrench and channel lock pliers to
attach the flexible connector to the adapters. Check that
connector is not kinked.
A
B
C
D
A. Gas pressure regulator
B. Use pipe-joint
compound.
C. Adapter (must have V2" male
pipe thread)
D. Flexible connector
E
H
G
F
E. Manual gas shutoff valve
E V2"or 3/4"gas pipe
G. Use pipe-joint
compound.
H. Adapter
Complete
Connection
1. Check that the gas pressure regulator shutoff valve is in the
"on" position.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow
these instructions can result in death,
fire, or electrical
shock.
5. Plug into a grounded 3 prong outlet.
6. Slide range into final location, making sure the rear leveling leg
slides into the slot of the anti-tip bracket.
2.
A. Gas pressure regulator shutoff valve
shown in the "on" position
Open the manual shutoff valve in the gas supply line. The valve
is open when the handle is parallel to the gas pipe.
On Ranges with a Storage Drawer:
1. Remove the storage drawer. See "Storage Drawer" section.
2. Use a flashlight to look underneath the bottom of the range.
3. Visually check that the rear range foot is inserted into the slot of
the anti-tip bracket.
On Ranges with a Warming
Drawer or Premium Storage
Drawer:
1=
Place the outside of your foot against the bottom front of the
warming drawer or premium storage drawer, and grasp the
lower right or left side of the control panel as shown.
NOTE: If your countertop is mounted with a backsplash, it may
be necessary to grasp the range higher than is shown in the
illustration.
A. Closed valve
B. Open valve
3. Test all connections
by brushing on an approved noncorrosive
leak-detection
solution. If bubbles appear, a leak is indicated.
Correct any leak found.
4.
Remove cooktop burner caps and grates from parts package.
Burner caps should be level when properly positioned. If burner
caps are not properly positioned, surface burners will not light.
Place burner grates over burners and caps.
B
/
\
C
A--
A. Burner base
B. Burner cap
C. Burner grate
2.
3.
Slowly attempt to tilt the range forward.
If you encounter immediate resistance, the range foot is
engaged in the anti-tip bracket.
If the rear of the range lifts more than W' (1.3 cm) off the floor
without resistance, stop tilting the range and lower it gently
back to the floor. The range foot is not engaged in the anti-tip
bracket.
Advertisement
