Amana AGP200VDW1 Installation Instructions Manual page 10

6.
1.
2.
Repeat steps 1 and 2 to ensure that the range foot is
engaged in the anti-tip bracket.
If the rear of the range lifts more than 1/2" (1.3 cm) off the floor
without resistance, the anti-tip bracket may not be installed
correctly. Do not operate the range without anti-tip bracket
installed and engaged. Please reference the "Assistance or
Service" section of the Use and Care Guide, or the cover or
"Warranty" section of the User Instructions, to contact
service.
! ¸ _ '_,_
L ®
Place a standard flat rack in oven.
Place level on the rack and check levelness of the range, first
side to side; then front to back.
7.
8.
9.
Slowly lower the cooktop until it snaps into position.
Push in and turn each surface burner control knob to the "HI"
position. The flame should light within 4 seconds.
If surface burners do not ignite, repeat steps 3 to 6.
oo
OFF oe
push to Turn MED
3. If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket.
4. Use a 3/8"drive ratchet and slip-joint pliers to adjust leveling
legs up or down until the range is level.
5. Push range back into position.
6. Check that rear leveling leg is engaged in the anti-tip bracket.
NOTE: Range must be level for satisfactory baking performance.
C _ _'_*_"_,_ O _[_e[cJ io_,
To Light Standing Pilot Lights:
Before using the range, the standing pilots must be lit. They will
stay lit after turning off the burners.
1. Make sure all controls are off and the oven and cooktop are
cool.
2. Remove surface grates from the cooktop.
3. Lift the cooktop by both front corners and hold it by the front
center edge.
4. Using a match, light both burner pilot lights.
5. The surface pilot flames should be 0.4"-0.6" (10-15 mm) high.
6.
A
,,,,.s
A. 0.4"-0.6" (10-15 mm)
If the pilot flame needs adjustment, use a flat-blade
screwdriver and turn the adjusting screw until the flame is of
the desired height.
A. Adjusting screw
10. Check each cooktop burner for proper flame. The small inner
cone should have a very distinct blue flame 1¼,, t o 1/2"(6.4 mm
to 13 mm) long. The outer cone is not as distinct as the inner
cone.
A. Outer cone
B. Inner cone
11. Turn the control knob quickly to the "LO" position after the
burner lights. If the flame goes out, turn the knob to the
"OFF" position.
12. Check each cooktop burner for proper low flame. The low
flame should be a minimum, steady blue flame. The flame
size should be 1¼,, t o 3/8"(6.4 mm to 9.5 mm) high.
13. Replace cooktop grates.
If the low flame needs adjusting:
1. Turn control knob to the "LO" setting and remove control
knob.
2. Insert a small flat-blade screwdriver into the valve stem. Turn
the valve adjusting screw to obtain the smallest flame that will
not go out when the control of a cold burner is quickly turned
from "HI" to "LO." Turn right to decrease flame height. Turn
left to increase flame height. Repeat for other cooktop
burners as needed.
A. Valve stem
3. Replace control knob
1. Make sure all controls are off and the oven is cool.
2. Open the oven door to remove oven racks and the oven
bottom tray.
10