MK Diamond Products MK-101-24 Owner's Manual & Operating Instructions page 37

MK-101-24
Horizontal Rough alignment
The Horizontal alignment will ensure that straight cuts (or Rip Cuts) are made.
(A)
Position Cutting Head
to normal Cut Depth.
(D)
Position Square flat on Movable
Cutting Table against Ruler/Stop.
Position front of Square
against Blade.
Horizontal Alignment Verification
(A)
Move the Cutting Table back and
forth to verify Blade is even
across all points of Square.
(B)
Move Guide Bar until Blade is
centered in Cutting Groove. Tighten
rear guide bar retaining bolt.
(E)
Move Guide Bar until Square
rests evenly across Blade.
(B)
Tighten Guide Bar
Retaining Bolts.
37
TROUBLESHOOTING
(C)
Pull Movable Cutting Table
to front of Tile Saw.
(C)
Move the Cutting Table back and
forth to re-verify Blade is even
across all points of Square.